The first one i made i could not post as it was for a DT project, so just the excuse i needed to make another one..lol..
Here Goes.. THIS IS A LONG POST!!!!
YOU WILL NEED!!
2 sheets of card,
Tool for scoring,
Take an A4 piece of card, fold an score lengthways at 4 inches.
Once folded in half you will have a few mm spare along the edge, just cut the litte strip off.
Measure from edge 4 inches, now on the opposite edge do the same 4 inches again.
You will have a slightly smaller square in the middle, with a 4 inch square either side.
Cut along the 4 inch lines you just measured, only upto the middle fold.
It should look like this.
The centre square fold ni half, an score like this.
The 2, 4 inch squares fold up to the centre fold,to create a triangle, then that is it the base for your card is done.
Should look like this..
You now need to make 2, 4 inch squares from card an 1 square for the centre, these are for you to matt an layer, decorate an add your image.
Go ahead an add papers, ribbons or what you wish to use.
Only put tape on to the top corners of the 4 inch squares an front facing part of the smaller middle square, like this.
These are the decorated squares that you need to attach to the base..
Completed card will look like this.
You will need to tease the card a little to get it to stand forward, i found laying them all down flat an re scoring along the centre fold, will help them stand, add a little embellishment just in front of all 3 squares, like all easel cards you need them there to stand..
Hope you enjoyed my tutorial.
Please link back to me if yu use this tutorial, would love to see your creations too..
That's it from me!!!!